5/17/2023 0 Comments Archatechural units in babacadIf you open the Type drop-down list in the Angle group, you’ll see a choice,Īmong others, between Decimal Degrees and Deg/Min/Sec. Click 0′-0 1⁄16″ (0) to maintain the precision for display of linear If you change the precision setting to 1⁄32″ and then use theĭISTANCE command to measure the distance between two features,ħ. However, the line is still 6′-31⁄32″ long. Nearest 1⁄16″ when queried (which, in the example, would be 6′-3ġ⁄16″). Precisely, such as a line 6′-31⁄32″ long, displays a length value to the If it’s set to 1⁄16″, any line that is drawn more This setting controls the degree of precision to which AutoCAD displaysĪ linear distance. 3 : The Precision drop-down list for Architectural units (left) and Group to display the choices of precision for Architectural unitsį igu re 3. Click the down arrow in the Precision drop-down list in the Length Then select Architectural again or leave it set toĦ. The way the units appear in the Sample Output group at the bottom Select some of the other Length unit types from the list, and notice Should set this to 0 because we won’t be using units smaller than aĥ. Linear distances are displayed to the nearest 1⁄16″. When you changed the linear unit specification fromĭecimal to Architectural, the number in the Precision drop-down list Notice the two Precision drop-down lists under the Length andĪngle groups. Within the Drawing Units dialog box, in the Length group, click theĪrrow in the Type drop-down list and select Architectural (metric Similarly, in theĪngle group, Decimal Degrees is the default.į igu re 3. The Length group, Decimal is currently selected. Choose Application menu ➢ Drawing Utilities ➢ Units to open theĭrawing Units dialog box (UNITS command) shown in Figure 3.2. 1 : Selecting the acad.dwt template from the Start Drawing toolģ. Expand the Templates menu within the Start Drawing tool on theĬreate page shown in Figure 3.1, and select the acad.dwt template.į igu re 3. With AutoCAD running, click the plus icon to the right of the drawingĢ. This chapter covers some of the tools for changing the basic parameters of a new drawing so that you can tailor it to the cabin project or to your own project.ġ. The units and other basic setup parameters applied to this new drawing are based on a prototype drawing with default settings-including those for the units. By default, the linear and angular units inside this drawing are set to decimal numbers. When you first start a new drawing, AutoCAD displays a blank drawing calledĭrawing#.dwg. Each of these linear and angular units is presented at the end of this chapter, but for now let’s focus on getting ready to begin drawing our cabin. The combination you choose will largely depend on the type of drawings you plan to prepare. Angular units can also be any of five types. When you draw lines of a precise length in AutoCAD, you use one of five kinds of linear units.
0 Comments
Leave a Reply. |